Phase 2 Clone Trooper Armor (No Helmet) Galactic Armory DIY

  

Here is the Galactic Republic Phase 2 Clone Trooper Armor from Galactic Armory and printed in PLA plastic and is unpainted. This model is suitable for Cosplay or display and will need to be sanded to remove the layer lines and painted to make a finished model.

It offers no protective properties and should not be used in high impact sports like paintball or airsoft. PLEASE NOTE: No Helmet is included. The model comes in 45 parts and is 392mm x 196mm x 382mm (Chest Plate). Should take 2 - 8 weeks to Complete.

PLEASE NOTE: You will need 4x (10mm x 60mm x 3mm) rectangular magnets & 24x (6mm x 3mm) magnets. The model comes in the following options. Standard - Armour is modelled on a 6 foot, 91kg man. Custom - Please send the measurements below in a message once sale is processed. Measurements needed (in mm please).

Thigh Length (from the back of your knee to where your buttocks begin). Shin Length (from just below the knee to the top of your ankle). When taking your measurements, please wear what you are planning to have on under the helmet or armour. While I will size your helmet or armour according to your measurements, the fit may need improvement.

I recommend adding padding to help get the ideal fit and comfort (please consider this when taking measurements). Please check your measurements; once sized and printed, I cannot reprint without charging again. Solamnus666Models is authorised to sell physical prints of the artist's Galactic Armory models.

All renderings of the model are provided to me by Galactic Armory. The 3D prints may have less detail than the supplied computer-generated renderings.