Kylo Ren Star Wars The Force Awakens Full Level 3 501st Approved Costume

  

FULL 501st approved Kylo Ren Costume (Soft Parts ONLY). This costume and all it's pieces are guaranteed to adhere to the official 501st Legion costume specifications for membership approval. Made from black 2x2 basketweave, monk's cloth or similarly textured thick weaved fabric.

Cape, cowl, hood and surcoat must be made from the same fabric. Worn on top of the surcoat. The hood is large enough to adequately accommodate the helmet. The hood should be a rounded pattern and does not come to a point. The cowl is wide enough to be abundantly gathered around the neck and shoulders.

The cape is tapered from the cowl to its end, and drapes along the wearer's back. The cape hangs below the wearer's belt, but does not extend below the knees. The edges of the cape are frayed. The hood must be worn up. The hood has no visible seam on top of the hood.

The hood is double layered resulting in a seam along the front edge. Made from black basketweave, monk's cloth or similarly textured thick weaved fabric. The weave consists of no more than 8 squares per inch and no less than 3 squares per square inch. Is sleeveless and floor length.

The skirt is constructed of four panels. The front, sides, and back seams are open directly below the belt to the floor. A single closed seam runs vertically down the front center. If a seam is present at the shoulders it should be constructed in a way that it is inconspicuous. Is constructed of two panels which are sewn together along the front, wearer's right side, and back.

Has an inconspicuous closure located on the wearer's left side. The top of the surcoat extends slightly past the apex of the wearer's shoulder.

The arm opening is constructed such that the fabric is rolled to the inside and sewn back onto itself; there is no noticeable resulting seam. The rear skirt panels have two vertical pleats right and left of center and directly below the belt.

The basket weave is coated or waxed such that it has a reflective sheen without significantly altering the drape of the fabric (more rigid). The weave is an equal 2x2 pattern with 4 squares per square inch. The weave is also slightly see through.

A small zipper at the neckline that is no longer than 4 inches. The tunic is made from matte black canvas material. Worn beneath the mid coat and extends to knee level. Worn beneath the surcoat and extends to wearers knee. Constructed with approximately 40 horizontal pleats.

Made from a canvas with a even basic weave. Piping is a twill weave. The under tunic is constructed with one split at the front starting at the belt.

Piping adorns the following sections. Front center hidden zipper has piping identical to the sleeves. Sleeves are made from matte black canvas.

Shirt is a black cotton material. The shirt is worn beneath the tunic.

It is constructed with approximately 35 pleats. The sleeves are form fitting, extend past the wrist and flare out at the cuff to be larger than the wearer's hand.

A zipper beginning at the armpit and ending at the base of the thumb runs down the inside seam of the sleeve. Made from thick canvas with a even basic weave. The sleeves are sewn to and shirt and should be recessed slightly from the arm opening on the under tunic. Piping is present down the seam where the zipper is present and is piped on both sides.

Composed of 6 strips of horizontally stacked leather (or leather-like material). Worn beneath the under tunic, and extends to the top of the wearer's neck.

Closes at the back of the wearers neck with Velcro. Made of rigid 9 oz. Thick leather, veg dyed black, 4 1/2 inches wide, and has two 1/2 inch leather straps at the top and bottom. Worn on top of the outer robe. Seamless around the wearer's body - the closure is behind the buckle with Velcro.

The buckle is semi-gloss black, rectangular, centered on the front of the wearer, and is the same height as the belt. The details of the buckle are as pictured. The saber clip is semi-gloss black, and mounted on the belt 2-3 inches behind the wearers right hip. The two half inch straps are weathered. Saber, Boots, Helmet, Mid-Coat and Pants. Mid-Coat Available for Sale through this company. This is a custom fit item. The item "Kylo Ren Star Wars The Force Awakens Full Level 3 501st Approved Costume" is in sale since Tuesday, June 14, 2016. This item is in the category "Clothing, Shoes & Accessories\Costumes, Reenactment, Theater\Costumes\Men". The seller is "badrabbitcosplay-666" and is located in Lake Mary, Florida. This item can be shipped to United States, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Colombia, Panama, Jamaica, Barbados, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, Gibraltar, Guadeloupe, Iceland, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Macao, Maldives, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.

• Brand: Bad Rabbit Cos
• Theme: Star Wars
• Style: Complete Outfit
• Size: Custom Made
• Color: Black